Quick Start Guide
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Models
- Chapter 1 Overview
- Chapter 2 System Wiring
- Chapter 3 Installation
- Chapter 4 General Wiring
- 4.1 Components Introduction
- 4.2 Wiring Electric Supply
- 4.3 Wire Interconnecting Cable
- 4.4 Face Recognition Terminal Power Supply Wiring (Optional)
- 4.5 Terminal Description
- 4.5.1 UART Related Terminal and Position
- 4.5.2 Main Control Board Terminal Description
- 4.5.3 Sub Control Board Terminal Description
- 4.5.4 BUS Terminal Description
- 4.5.5 Access Control Board Terminal Description
- 4.5.6 Access Control Board UART Description
- 4.5.7 RS-485 Wiring
- 4.5.8 RS-232 Wiring
- 4.5.9 Barrier Control Wiring
- 4.5.10 Alarm Output Wiring
- Chapter 5 Device Settings
- Chapter 6 Activation
- Appendix A. DIP Switch Description
- Appendix B. Event and Alarm Type
- Appendix C. Table of Audio Index Related Content
- Appendix D. Error Code Description
- Appendix E. Communication Matrix and Device Command
Access Control Board Terminal Descripon
the passage
exit. UART 1
in the main
control board
corresponds
to the
entrance
card reader,
and UART 5
in the main
control board
corresponds
to the exit
card reader.
●
If the user
has
congured a
guest card,
the exit
needs to be
connected to
two card
readers, one
with the DIP
4 and the
other with
the DIP 3.
The card
reader 3 and
the card
receiver are
used
together, the
ordinary user
swipes the
card on the
card reader
4, and the
guest user
swipes the
card on the
DS-K3Y411X Series Flap Barrier Quick Start Guide
26