Quick Start Guide
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Models
- Chapter 1 Overview
- Chapter 2 System Wiring
- Chapter 3 Installation
- Chapter 4 General Wiring
- 4.1 Components Introduction
- 4.2 Wiring Electric Supply
- 4.3 Wire Interconnecting Cable
- 4.4 Face Recognition Terminal Power Supply Wiring (Optional)
- 4.5 Terminal Description
- 4.5.1 UART Related Terminal and Position
- 4.5.2 Main Control Board Terminal Description
- 4.5.3 Sub Control Board Terminal Description
- 4.5.4 BUS Terminal Description
- 4.5.5 Access Control Board Terminal Description
- 4.5.6 Access Control Board UART Description
- 4.5.7 RS-485 Wiring
- 4.5.8 RS-232 Wiring
- 4.5.9 Barrier Control Wiring
- 4.5.10 Alarm Output Wiring
- Chapter 5 Device Settings
- Chapter 6 Activation
- Appendix A. DIP Switch Description
- Appendix B. Event and Alarm Type
- Appendix C. Table of Audio Index Related Content
- Appendix D. Error Code Description
- Appendix E. Communication Matrix and Device Command
Access Control Board Terminal Descripon
card reader
3.
●
This is the
RS-485
interface,
which cannot
be switched
by dialing.
Power Output 2 5 V 5 VDC Power Output /
G Grounding
RS-232 Interface G Grounding
●
This is the
RS-232
interface,
which cannot
be switched
by dialing.
●
By default,
there is no
QR code
scanner on
the le
pedestal of
the device
entrance. If
you need to
connect an
addional QR
c
ode
scanner, you
need to
connect it
through the
RS-232
interface
here. Aer
the cable is
c
onnected to
the RS-232
interface, it
RS-232 G- Connect to RS-232G-
RS-232 G+ Connect to Card Reader RS-232G+
G Grounding
RS-232 H- Connect to RS-232H-
RS-232 H+ Connect to Card Reader RS-232H+
DS-K3Y411X Series Flap Barrier Quick Start Guide
27