Quick Start Guide
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Models
- Chapter 1 Overview
- Chapter 2 System Wiring
- Chapter 3 Installation
- Chapter 4 General Wiring
- 4.1 Components Introduction
- 4.2 Wiring Electric Supply
- 4.3 Wire Interconnecting Cable
- 4.4 Face Recognition Terminal Power Supply Wiring (Optional)
- 4.5 Terminal Description
- 4.5.1 UART Related Terminal and Position
- 4.5.2 Main Control Board Terminal Description
- 4.5.3 Sub Control Board Terminal Description
- 4.5.4 BUS Terminal Description
- 4.5.5 Access Control Board Terminal Description
- 4.5.6 Access Control Board UART Description
- 4.5.7 RS-485 Wiring
- 4.5.8 RS-232 Wiring
- 4.5.9 Barrier Control Wiring
- 4.5.10 Alarm Output Wiring
- Chapter 5 Device Settings
- Chapter 6 Activation
- Appendix A. DIP Switch Description
- Appendix B. Event and Alarm Type
- Appendix C. Table of Audio Index Related Content
- Appendix D. Error Code Description
- Appendix E. Communication Matrix and Device Command
Access Control Board Terminal Descripon
passes
through the
embedded
pipe and
connects
with the QR
code on the
le.
Power Input +24 V 24 VDC Power Input /
GND Grounding
Event Input C1 Event Alarm Input 1 The event
alarm input
hardware
interface is
remaining
open, and only
supports access
to remaining
open signals,
which can be
linked to the
host buzzer
output, card
reader buzzer
output, alarm
relay output,
door open relay
output, etc.
G Grounding
C2 Event Alarm Input 2
Exit Buon B2 Door 2 Signal Input /
G Grounding
B1 Door 1 Signal Input
Door Lock (Relay) D1- Door 1 Relay Output (Dry Contact) If necessary,
the door lock
relay can be
used to control
the third-party
barrier switch.
D1+
DS-K3Y411X Series Flap Barrier Quick Start Guide
28