Quick Start Guide
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Models
- Chapter 1 Overview
- Chapter 2 System Wiring
- Chapter 3 Installation
- Chapter 4 General Wiring
- 4.1 Components Introduction
- 4.2 Wiring Electric Supply
- 4.3 Wire Interconnecting Cable
- 4.4 Face Recognition Terminal Power Supply Wiring (Optional)
- 4.5 Terminal Description
- 4.5.1 UART Related Terminal and Position
- 4.5.2 Main Control Board Terminal Description
- 4.5.3 Sub Control Board Terminal Description
- 4.5.4 BUS Terminal Description
- 4.5.5 Access Control Board Terminal Description
- 4.5.6 Access Control Board UART Description
- 4.5.7 RS-485 Wiring
- 4.5.8 RS-232 Wiring
- 4.5.9 Barrier Control Wiring
- 4.5.10 Alarm Output Wiring
- Chapter 5 Device Settings
- Chapter 6 Activation
- Appendix A. DIP Switch Description
- Appendix B. Event and Alarm Type
- Appendix C. Table of Audio Index Related Content
- Appendix D. Error Code Description
- Appendix E. Communication Matrix and Device Command
Note
●
Y
ou can swch between RS-485 and RS-232 via the DIP switch on the access control board. For
details about DIP switch and swiching method, see
Access Control Board UART Descripon .
●
F
or details about DIP switch operaon, see
DIP Switch Descripon .
4.5.6 Access Control Board UART Descripon
You can set the device mode, switch the communicaon mode of the corresponding UART, and
inialize the device through the DIP on the access control board.
The DIP s
witch of the access control board is shown in the gure below:
Note
The diagram is for reference only.
DS-K3Y411X Series Flap Barrier Quick Start Guide
30