Quick Start Guide
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Models
- Chapter 1 Overview
- Chapter 2 System Wiring
- Chapter 3 Installation
- Chapter 4 General Wiring
- 4.1 Components Introduction
- 4.2 Wiring Electric Supply
- 4.3 Wire Interconnecting Cable
- 4.4 Face Recognition Terminal Power Supply Wiring (Optional)
- 4.5 Terminal Description
- 4.5.1 UART Related Terminal and Position
- 4.5.2 Main Control Board Terminal Description
- 4.5.3 Sub Control Board Terminal Description
- 4.5.4 BUS Terminal Description
- 4.5.5 Access Control Board Terminal Description
- 4.5.6 Access Control Board UART Description
- 4.5.7 RS-485 Wiring
- 4.5.8 RS-232 Wiring
- 4.5.9 Barrier Control Wiring
- 4.5.10 Alarm Output Wiring
- Chapter 5 Device Settings
- Chapter 6 Activation
- Appendix A. DIP Switch Description
- Appendix B. Event and Alarm Type
- Appendix C. Table of Audio Index Related Content
- Appendix D. Error Code Description
- Appendix E. Communication Matrix and Device Command
Safety Instrucon
These instrucons are intended to ensure that user can use the product correctly to avoid danger
or property loss.
The precauon measure is divided into Dangers and Cauons:
Dangers: Neglecng any of the warnings may cause serious injury or death.
Cauons: Neglecng any of the cauons may cause injury or equipment damage.
Dangers: Follow these safeguards to prevent
serious injury or death.
Cauons: Follow these precauons to prevent
potenal injury or material damage.
Danger:
●
In the use of the product, you must be in strict compliance with the electrical safety regulaons
of the naon and region.
●
The equipment must be connected to an earthed mains socket-outlet.
●
Shock hazard! Disconnect all power sources before maintenance.
●
Do not touch the bare metal contacts of the inlets aer the circuit breaker is turned o.
Electricity sll exists.
●
indicates hazardous live and the external wiring connected to the terminals requires
installaon by an instructed person.
●
K
eep body parts away from fan blades. Disconnect the power source during servicing.
●
Keep body parts away from motors. Disconnect the power source during servicing.
●
To prevent possible hearing damage, do not listen at high volume levels for long periods.
●
All the electronic operaon should be strictly compliance with the electrical safety regulaons,
r
e prevenon regulaons and other related regulaons in your local region.
●
Do not connect several devices to one power adapter as adapter overload may cause over-heat
or re hazard.
●
Please mak
e sure that the power has been disconnected before you wire, install or dismantle the
device.
If the top caps should be open and the device should be powered on for maintenance, make
sure:
1. Power o the fan to prevent the operator from geng injured accidentally.
2.
Do not touch bare high-voltage components.
3. Make sure the switch’s wiring sequence is correct aer maintenance.
●
Please make sure that the power has been disconnected before you wire, install or dismantle the
device.
●
When the product is installed on wall or ceiling, the device shall be rmly xed.
●
If smok
e, odors or noise rise from the device, turn o the power at once and unplug the power
cable, and then please contact the service center.
DS-K3Y411X Series Flap Barrier Quick Start Guide
v