User's Manual

5. Select a picture from the PC running the client.
Note
The picture should be in JPG or JPEG format and smaller than 200 KB.
6. Oponal: Enable V
erify by Device to check whether the facial recognion device managed in
the client can recognize the face in the photo.
7. Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons .
6.4.5 Take a Photo via Client
When adding person, you can take a photo of the person by the webcam of the PC running the
client and set this photo as the person's prole.
Before You Start
Add at least one access control device checking whether the face in the photo can be recognized
by the facial recognion device managed by the client.
Steps
1. Enter Person module.
2. Select an organizaon in the organizaon list to add the person and click Add.
Note
Enter the person's basic informaon rst. For details about conguring person's basic
informaon, refer to Congure Basic Informaon .
3. Click Add F
ace in the Basic Informaon panel.
4. Select Take Photo.
5. Connect the face scanner to the PC running the client.
6. Oponal: Enable V
erify by Device to check whether the facial recognion device managed in
the client can recognize the face in the photo.
7. Take a photo.
1) Face to the webcam of the PC and make sure your face is in the middle of the collecng
window.
2)
Click
to capture a face photo.
3) Oponal: Click to capture again.
4)
Click OK to save the captured photo.
8. Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons.
DS-K3Y501 Flap Barrier User Manual
42