User's Manual

Click to enter the remote conguraon page.
Click System → General to congure the device name and overwrite record les parameter.
Click Save.
6.12.3 Edit Time
Steps
1. Click Maintenance and Management → Device to enter the device list.
2. Click to enter the remote conguraon page.
3. Click S
ystem → Time to
congure the me zone.
4. Oponal: Check Enable NTP and set the NTP server address, the NTP port, and the
synchronizaon interval.
5. Oponal: Check Enable DST and set the DST start me, end me and the bias.
6. Click Save.
6.12.4 Set System Maintenance
You can reboot the device remotely, restore the device to default sengs, etc.
Steps
1. Click Maintenance and Management → Device to enter the device list.
2. Click to enter the remote conguraon page.
3. Click S
ystem → System Maintenance .
4. Maintain the device.
Reboot
The device starts reboong.
Restore Default Sengs
Restore the device sengs to the default ones, excluding the IP address.
R
estore All
Restore the device parameters to the default ones. The device should be acvated
aer
restoring.
5. Remotely upgrade the device.
1) In the Remote Upgrade part, select an upgrade type.
Note
• You need to set the device ID before upgrading if you select Controller Upgrade File as the
r
emote upgrade type.
• Only the card reader that connected via RS-485 protocol supports upgrading.
2) Click ... t
o select an upgrade le.
3) Click Upgrade to start upgrading.
DS-K3Y501 Flap Barrier User Manual
100