User's Manual

Table Of Contents

Note

For detailed informaon about burying and wiring interconnecng cables, see Wire

Interconnecng Cable .

6. Seal the boom of the

turnsle to avoid water from entering.

7. According to the entrance and exit marks on the pedestals, move the pedestals to the

corresponded posions.

Note

Make sure the installaon holes on the pedestals and the base are aligned with each other.

8. Secur

e the pedestals with expansion bolts.

Note

• Do not immerse the pedestal in the water. In special circumstances, the immersed height

should be no mor

e than 150 mm.

• The installaon footprint is as follows:

Figure 3-4 Installaon Footprint

9. R

emove the auxiliary scks at the boom of the device aer the device is fully installed. And

then use the concrete to seal the holes.

DS-K3Y501 Flap Barrier User Manual