User's Manual

Chapter 4 Device Sengs
Aer installaon and wiring completed, the turnsle will learn the open and closed posion
automacally.
Aer the learning, the turnsle is in the normal mode. You can also set the turnsle to test mode,
passing mode and memory mode, pair the keyfob, inialize the hardware, switching between
RS-485 communicaon mode and RS-232 communicaon mode, and view relay output NO/NC
diagram by seng the DIP switch on the main control board.
• Normal Mode: The device will work properly.
• Test Mode: Test mode is the same as the normal mode except that the device cannot report the
alarm, the event, or the people counng informaon to the center.
• Passing Mode: There are 9 passing modes, including controlled bi-direcon, controlled entrance
and prohibited exit, controlled entrance and free exit, free bi-direcon, free entrance and
controlled exit, free entrance and prohibited exit, prohibited bi-direcon, prohibited entrance
and free exit.
• Memory Mode: By default, the memory mode is enabled. When mulple cards are presented
and authencated, it allows mulple persons passing through the lane. When it counts the
passing people number is equal to the card presented mes, or no person passing through the
lane aer the last person passing, the barriers will be closed.
Note
You can also set the DIP switch on the main control board to control the entrance and exit
c
ontrolling type, keyfob pairing, etc. For details about the DIP switch value, see DIP Switch .
4.1 Pair Keyfob
(Oponal)
Pair the remote control to the device through DIP switch to open/close the barrier remotely.
Before You Start
Ask our technique supports or sales and purchase the keyfob.
Steps
1. Power o the
turnsle.
2. Set the No.4 switch of the 8-digit DIP Switch on the main control board according to the gure
below.
3. P
ower on the turnsle and it will enter the keyfob pairing mode.
4. Hold the Close buon for more than 10 seconds.
DS-K3Y501 Flap Barrier User Manual
23