User's Manual

Import Devices in a Batch
The devices can be added to the soware in a batch by entering the device informaon in the pre-
dened CSV le.
Steps
1. Enter the Device Management page
2. Click Add to open the adding device window.
3. Select Batch Import as the adding mode.
4. Click Export Template and then save the pre-dened template (CSV le) on your PC.
5. Open the e
xported template
le and enter the required informaon of the devices to be added
on the corresponding column.
Adding Mode
You can enter 0 or 1 which indicated dierent adding modes. 0 indicates that the device is
added by IP address or domain name; 1 indicates that the device is added via EHome.
Address
Edit the address of the device. If you set 0 as the adding mode, you should enter the IP
address or domain name of the device; if you set 1 as the adding mode, this led is not
r
equired.
Port
Enter the device port No. The default value is 8000.
Device Informaon
If you set 0 as the adding mode, this eld is not required. If you set 1 as the adding mode,
en
ter the EHome account.
User Name
Enter the device user name. By default, the user name is admin.
Password
If you set 0 as the adding mode, enter the password. If you set 1 as the adding mode, enter
the EHome key.
Cauon
The password strength of the device can be automacally checked. We highly recommend
y
ou change the password of your own choosing (using a minimum of 8 characters, including
at least three kinds of following categories: upper case leers, lower case leers, numbers,
and special characters) in order to increase the security of your product. And we recommend
you reset your password regularly, especially in the high security system, reseng the
password monthly or weekly can beer protect your product.
Proper conguraon of all passwords and other security sengs is the responsibility of the
installer and/or end-user.
DS-K3Y501 Flap Barrier User Manual
36