User's Manual

Congure Parameters for Access Control Device
Aer adding the access control device, you can congure its parameters.
Steps
1. Click Access Control → Advanced Funcon → De
vice Parameter .
Note
If you can nd Device Parameter in the Advanced Funcon list, Hover the cursor on the
Adv
anced Funcon, and then Click
to select the Device Parameter to be displayed.
2. Select an access de
vice to show its parameters on the right page.
3. Turn the switch to ON to enable the corresponding funcons.
Note
• The displayed parameters may vary for dierent access control devices.
•
Some of the following parameters are not listed in the Basic Informaon page, click More to
edit the parameters.
RS-485 Comm. Redundancy
Y
ou should enable this funcon if you wire the RS-485 card reader to the access control
device redundantly.
4. Click OK.
5. Oponal: Click Cop
y to, and then select the access control device(s) to copy the parameters in
the page to the selected device(s).
Congure Parameters for Door
Aer adding the access control device, you can congure its access point door parameters.
Steps
1. Click Access Control → Advanced Funcon → De
vice Parameter .
2. Select an access control device on the le panel, and then click
to show the doors or oors
of
the selected device.
3. Select a door or oor to show its parameters on the right page.
4. E
dit the door or oor parameters.
Note
• The displayed parameters may vary for dierent access control devices.
•
Some of the following parameters are not listed in the Basic Informaon page, click More to
edit the parameters.
Name
DS-K3Y501 Flap Barrier User Manual
57