User's Manual

1. Click Access Control → Advanced Funcon → Cus
tom Wiegand to enter the Custom Wiegand
page.
2. Select a custom Wiegand on the le.
3. Create a Wiegand name.
Note
Up to 32 characters are allowed in the custom Wiegand name.
4. Click Select De
vice to select the access control device for seng the custom wiegand.
5. Set the parity mode according to the property of the third party card reader.
Note
• Up to 80 bits are allowed in the total length.
•
The odd parity start bit, the odd parity length, the even parity start bit and the even parity
length range from 1 to 80 bit.
• The start bit of the card ID, the manufacturer code, the site code, and the OEM should range
from 1 to 80 bit.
6. Se
t output transformaon rule.
1) Click Set Rule to open the Set Output Transformaon Rules window.
Figure 6-3 Set Output Transformaon Rule
2) Select rules on the le list.
The select
ed rules will be added to the right list.
3) Oponal: Dr
ag the rules to change the rule order.
4) Click OK.
DS-K3Y501 Flap Barrier User Manual
66