User's Manual

Steps
Note
The linkage
acons should be supported by the device.
1. Click Access Con
trol → Linkage Conguraon .
2. Select the access control device from the list on the le.
3. Click Add to add a new linkage.
4. Select Event Linkage as the event source.
5. select the event type and detailed event to set the linkage.
6. In the Linkage Target area, set the property target to enable this acon.
Buzzer on Controller
The audible w
arning of access control device will be triggered.
Capture
An event-related picture will be captured when the selected event happens.
Recording
An event-related picture will be captured when the selected event happens.
Note
The device should support recording.
Buzzer on Reader
The audible w
arning of card reader will be triggered.
Alarm Output
The alarm output will be triggered for nocaon when the selected event happens
Alarm Input
Arm or disarm the alarm input.
Note
The device should support alarm input funcon.
Access Point
The door s
tatus of open, close, remain open, or remain close will be triggered.
Note
The target door and the source door cannot be the same one.
Audio Play
The audio pr
ompt will be triggered. And the select audio index related audio content will be
played according to the congured play mode.
7. Click Save.
8. Oponal:
Aer adding the device linkage, you can do one or more of the followings:
DS-K3Y501 Flap Barrier User Manual
73