User's Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Model
- Chapter 1 Overview
- Chapter 2 Appearance
- Chapter 3 Installation
- Chapter 4 Wiring
- Chapter 5 Activation
- Chapter 6 Quick Operation
- Chapter 7 Basic Operation
- Chapter 8 Operation via Web Browser
- 8.1 Login
- 8.2 Person Management
- 8.3 Configuration
- 8.3.1 View Device Information
- 8.3.2 Set Time
- 8.3.3 Set DST
- 8.3.4 View Open Source Software License
- 8.3.5 Upgrade and Maintenance
- 8.3.6 Security Mode Settings
- 8.3.7 Change Administrator's Password
- 8.3.8 View Device Arming/Disarming Information
- 8.3.9 Network Settings
- 8.3.10 Set Audio Parameters
- 8.3.11 Set Image Parameters
- 8.3.12 Set Authentication Parameters
- 8.3.13 Temperature Measurement Settings
- 8.3.14 Set Biometric Parameters
- 8.3.15 Visitor Settings
- 8.3.16 Set Screen Saver Picture
- Appendix A. Tips When Collecting/Comparing Face Picture
- Appendix B. Tips for Installation Environment
- Appendix C. Dimension
- Appendix D. Communication Matrix and Device Command
Chapter 7 Basic Operaon
7.1 Visitor Check In
7.1.1 Reserved Visitor Check In
Visitors can make appointments on the plaorm in advance and check in by phone number or the
visitor code generated for successful reservaon.
Before You Start
Fill in the visitor
informaon on the plaorm in advance.
Steps
1.
Tap on the right side of the home page to enter the visitor code or the last 4 digits of the visitor's
phone number.
Figure 7-1 Reserved Visitor Check In
Note
●
The page and instrucons are based on dual-screen devices and are referable for single-screen
devices.
●
Go to Set Basic Parameters and set the length of the visitor code.
●
Visitor
reservaon is disabled by default. Go to Set Basic Parameters and enable Visitor
Reservaon.
DS-K5032-3XFD Visitor Terminal User Manual
13