User's Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Model
- Chapter 1 Overview
- Chapter 2 Appearance
- Chapter 3 Installation
- Chapter 4 Wiring
- Chapter 5 Activation
- Chapter 6 Quick Operation
- Chapter 7 Basic Operation
- Chapter 8 Operation via Web Browser
- 8.1 Login
- 8.2 Person Management
- 8.3 Configuration
- 8.3.1 View Device Information
- 8.3.2 Set Time
- 8.3.3 Set DST
- 8.3.4 View Open Source Software License
- 8.3.5 Upgrade and Maintenance
- 8.3.6 Security Mode Settings
- 8.3.7 Change Administrator's Password
- 8.3.8 View Device Arming/Disarming Information
- 8.3.9 Network Settings
- 8.3.10 Set Audio Parameters
- 8.3.11 Set Image Parameters
- 8.3.12 Set Authentication Parameters
- 8.3.13 Temperature Measurement Settings
- 8.3.14 Set Biometric Parameters
- 8.3.15 Visitor Settings
- 8.3.16 Set Screen Saver Picture
- Appendix A. Tips When Collecting/Comparing Face Picture
- Appendix B. Tips for Installation Environment
- Appendix C. Dimension
- Appendix D. Communication Matrix and Device Command
Saving Visitor Records
When the funcon is enabled, visitor informaon will be recorded for the rst-me visit. When
revisits, the visitor only need to present his/her
credenal for the device to read and the
informaon will be displayed on screen.
Auto Check Out
When the funcon is enabled, system will check out all visitors at 24 o'clock every day.
Visitor Code Length
You can set the visitor code length of 4 or 6 digits.
Export Data
You can export captured picture or visitor records to your USB ash drive.
Before You Start
Plug in the USB ash drive.
Note
The supported USB ash drive format is FAT32. Make sure the spare space is larger then 512 M.
Steps
1.
Tap in the top right corner of the home page. Tap Data Management to enter the page.
Figure 7-16 Data Management
DS-K5032-3XFD Visitor Terminal User Manual
31