User's Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Model
- Chapter 1 Overview
- Chapter 2 Appearance
- Chapter 3 Installation
- Chapter 4 Wiring
- Chapter 5 Activation
- Chapter 6 Quick Operation
- Chapter 7 Basic Operation
- Chapter 8 Operation via Web Browser
- 8.1 Login
- 8.2 Person Management
- 8.3 Configuration
- 8.3.1 View Device Information
- 8.3.2 Set Time
- 8.3.3 Set DST
- 8.3.4 View Open Source Software License
- 8.3.5 Upgrade and Maintenance
- 8.3.6 Security Mode Settings
- 8.3.7 Change Administrator's Password
- 8.3.8 View Device Arming/Disarming Information
- 8.3.9 Network Settings
- 8.3.10 Set Audio Parameters
- 8.3.11 Set Image Parameters
- 8.3.12 Set Authentication Parameters
- 8.3.13 Temperature Measurement Settings
- 8.3.14 Set Biometric Parameters
- 8.3.15 Visitor Settings
- 8.3.16 Set Screen Saver Picture
- Appendix A. Tips When Collecting/Comparing Face Picture
- Appendix B. Tips for Installation Environment
- Appendix C. Dimension
- Appendix D. Communication Matrix and Device Command
Set Network
Figure 7-20 Set Network
Select Wired or Wireless.
Note
Disconnect the wired network before connecng a Wi-Fi.
Wired
Note
Make sure the device has connected to a network.
If enable DHCP, the system will assign the IP address and other parameters automacally.
If disable DHCP, you should set the IP address, the subnet mask, and the gateway.
Wireless
Select a Wi-Fi and enter the Wi-Fi's password to get connected.
Tap OK. Or if you do not want to set the network parameters, tap Skip to skip network sengs.
Visitor Check In
Sengs
Set the items that need to be lled and whether they are required elds when checked in.
DS-K5032-3XFD Visitor Terminal User Manual
36