User's Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Model
- Chapter 1 Overview
- Chapter 2 Appearance
- Chapter 3 Installation
- Chapter 4 Wiring
- Chapter 5 Activation
- Chapter 6 Quick Operation
- Chapter 7 Basic Operation
- Chapter 8 Operation via Web Browser
- 8.1 Login
- 8.2 Person Management
- 8.3 Configuration
- 8.3.1 View Device Information
- 8.3.2 Set Time
- 8.3.3 Set DST
- 8.3.4 View Open Source Software License
- 8.3.5 Upgrade and Maintenance
- 8.3.6 Security Mode Settings
- 8.3.7 Change Administrator's Password
- 8.3.8 View Device Arming/Disarming Information
- 8.3.9 Network Settings
- 8.3.10 Set Audio Parameters
- 8.3.11 Set Image Parameters
- 8.3.12 Set Authentication Parameters
- 8.3.13 Temperature Measurement Settings
- 8.3.14 Set Biometric Parameters
- 8.3.15 Visitor Settings
- 8.3.16 Set Screen Saver Picture
- Appendix A. Tips When Collecting/Comparing Face Picture
- Appendix B. Tips for Installation Environment
- Appendix C. Dimension
- Appendix D. Communication Matrix and Device Command
You can view the current logo picture.
2.
Plug in the USB ash drive.
Note
The supported USB ash drive format is FAT32.
3.
Tap Add and select a logo picture from the USB
ash drive.
Note
The supported le size is less than 100 KB. The added picture will be cropped to 400 × 400.
4.
Oponal: Tap Restore Default, the device will use the default logo.
5.
Oponal: Tap Add Again, you can select the logo picture again.
6.
Oponal: Tap on the upper le corner, you can exit the page.
Screen Saver
Sengs
Manage the displayed picture on the visitor screen when the device is in screen saver mode.
Steps
1.
Tap in the top right corner of the home page. Tap Custom Sengs → Screen Saver .
Figure 7-23 screen saver
2.
Plug in the USB ash drive.
DS-K5032-3XFD Visitor Terminal User Manual
41