User's Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Model
- Chapter 1 Overview
- Chapter 2 Appearance
- Chapter 3 Installation
- Chapter 4 Wiring
- Chapter 5 Activation
- Chapter 6 Quick Operation
- Chapter 7 Basic Operation
- Chapter 8 Operation via Web Browser
- 8.1 Login
- 8.2 Person Management
- 8.3 Configuration
- 8.3.1 View Device Information
- 8.3.2 Set Time
- 8.3.3 Set DST
- 8.3.4 View Open Source Software License
- 8.3.5 Upgrade and Maintenance
- 8.3.6 Security Mode Settings
- 8.3.7 Change Administrator's Password
- 8.3.8 View Device Arming/Disarming Information
- 8.3.9 Network Settings
- 8.3.10 Set Audio Parameters
- 8.3.11 Set Image Parameters
- 8.3.12 Set Authentication Parameters
- 8.3.13 Temperature Measurement Settings
- 8.3.14 Set Biometric Parameters
- 8.3.15 Visitor Settings
- 8.3.16 Set Screen Saver Picture
- Appendix A. Tips When Collecting/Comparing Face Picture
- Appendix B. Tips for Installation Environment
- Appendix C. Dimension
- Appendix D. Communication Matrix and Device Command
Figure 8-4 Upgrade and Maintenance Page
Click Reboot to reboot the device.
Restore Parameters
Click Conguraon → System → Maintenance → Upgrade & Maintenance .
Restore All
All parameters will be restored to the factory sengs. You should acvate the device before
usage.
Default
The device will restore to the default
sengs, except for the device IP address and the user
informaon.
Logo Management
Click Conguraon → System → Maintenance → Upgrade & Maintenance .
Click to select a local image.
Click Import to import the logo image.
Click Delete to delete the logo image.
Note
The logo image shall be no larger than 100 kb with a resoluon of 400 × 400. Refer to Logo
Management for details.
Upgrade
Click Conguraon → System → Maintenance → Upgrade & Maintenance .
Select an upgrade type from the drop-down list. Click and select the upgrade le from your
local PC. Click Upgrade to start upgrading.
DS-K5032-3XFD Visitor Terminal User Manual
47