User's Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Model
- Chapter 1 Overview
- Chapter 2 Appearance
- Chapter 3 Installation
- Chapter 4 Wiring
- Chapter 5 Activation
- Chapter 6 Quick Operation
- Chapter 7 Basic Operation
- Chapter 8 Operation via Web Browser
- 8.1 Login
- 8.2 Person Management
- 8.3 Configuration
- 8.3.1 View Device Information
- 8.3.2 Set Time
- 8.3.3 Set DST
- 8.3.4 View Open Source Software License
- 8.3.5 Upgrade and Maintenance
- 8.3.6 Security Mode Settings
- 8.3.7 Change Administrator's Password
- 8.3.8 View Device Arming/Disarming Information
- 8.3.9 Network Settings
- 8.3.10 Set Audio Parameters
- 8.3.11 Set Image Parameters
- 8.3.12 Set Authentication Parameters
- 8.3.13 Temperature Measurement Settings
- 8.3.14 Set Biometric Parameters
- 8.3.15 Visitor Settings
- 8.3.16 Set Screen Saver Picture
- Appendix A. Tips When Collecting/Comparing Face Picture
- Appendix B. Tips for Installation Environment
- Appendix C. Dimension
- Appendix D. Communication Matrix and Device Command
Figure 8-8 Set Audio Parameters
Drag the block to adjust the output volume.
Click Save to save the sengs aer the conguraon.
You can also enable Voice Prompt.
Note
The funcons vary according to dierent models. Refers to the actual device for details.
8.3.11 Set Image Parameters
Set brightness, contrast, saturaon and hue parameters.
Steps
1.
Click Conguraon → Image .
2.
Congure the parameters to adjust the image.
Brightness
Drag the block or enter the value to adjust the live video's brightness. The value of brightness
is set 64 by default.
Contrast
Drag the block or enter the value to adjust the live video's contrast. The value of contrast is
set 32 by default.
Saturaon
Drag the block or enter the value to adjust the live video's saturaon. The value of saturaon
is set 64 by default.
Hue
Drag the block or enter the value to adjust the live video's hue. The value of hue is set 48 by
default.
DS-K5032-3XFD Visitor Terminal User Manual
54