User's Manual

Safety
Instrucon
Warning
•
The w
orking temperature of the device is from -30 °C to 50 °C.
•
All the electronic
operaon should be strictly compliance with the electrical
safety regulaons, re prevenon regulaons and other related regulaons in
your local region.
•
Please use the power adapter, which is provided by normal company. The power
consumpon cannot be less than the required value.
•
Do not c
onnect several devices to one power adapter as adapter overload may
cause over-heat or
re hazard.
•
Please mak
e sure that the power has been disconnected before you wire, install
or dismantle the device.
•
When the product is installed on wall, the device shall be
rmly xed.
•
If smoke, odors or noise rise from the device, turn
o the power at once and
unplug the po
wer cable, and then please contact the service center.
•
If the product does not work properly, please contact your dealer or the nearest
service center. Never
aempt to disassemble the device yourself. (We shall not
assume an
y responsibility for problems caused by unauthorized repair or
maintenance.)
Cauon
•
Do not dr
op the device or subject it to physical shock, and do not expose it to
high electromagnesm
radiaon. Avoid the equipment installaon on vibraons
surface or places subject to shock (ignorance can cause equipment damage).
•
Do not place the device in extremely hot (refer to the
specicaon of the device
f
or the detailed operang temperature), cold, dusty or damp locaons, and do
not expose it to high electromagnec radiaon.
•
The device cover hall should be kept from rain and moisture.
•
Exposing the equipment to direct sun light, low
venlaon or heat source such
as heater or radiator is forbidden (ignorance can cause re danger).
•
Do not aim the device at the sun or extra bright places. A blooming or smear
may occur otherwise (which is not a
malfuncon however), and
aecng the
endurance of sensor at the same me.
POE & Wi-Fi Doorbell Camera User Manual
vii