User's Manual

5 Local Operaon
5.1 Local Conguraon
5.1.1 Edit Network Parameters
Aer
acvang, you should edit the network parameters.
Steps
1.
Hold * and # at the same me to enter the authencaon page.
2.
Authencate
via administrator.
-
Authencate face/card/ngerprint to login.
-
Press # to enter the password to login.
3.
Swritch to Network sengs according to the ps on the page. Press # t
o enter
the sengs page.
4.
E
dit the parameters according to your needs.
5.
Press * to save and exit.
5.1.2 Door Staon
Sengs
Edit the parameters of the door staon (including but not limited to, community No.,
building No., oor No., room No. and device mode).
Steps
1.
Congure the parameters according to the actual needs.
Note
•
Outer door staon can only edit the Community No., Project No. and No.
•
The No. of the main door staon is 0.
•
The No. of sub door staons should be larger than 0 and ranges from 1 to 99.
•
E
ach unit should add 1 main door staon. Up to 8 sub door staons can be
added t
o the main door staon.
2.
Oponal: Adjus
t the brightness of the screen.
3.
Oponal: Enable the Channel Mode acc
ording to your needs.
4.
Oponal: Select the languag
e.
Video Intercom D Series Door Staon User Manual
25