User's Manual

Figure 6-17 Elevator Control
2.
Check t
o enable elevator control funcon.
3.
Select an Ele
vator No., and select an elevator controller type for the elevator.
4.
Set the
Negave Floor.
5.
Select the Interface Type as RS-485 or Network Interface. And enable the
elevator control.
-
If you select RS-485, make sure you have connected the door staon to the
ele
vator controller with RS-485 wire.
-
If you select Network interface, enter the elevator controller's IP address,
port No., user name, and password.
6.
Click Save to enable the sengs.
Note
•
Up t
o 4 elevator controllers can be connected to one door staon.
•
Up t
o 10 negave
oors can be added.
•
Make sure the interface types of elevator controllers, which are connected
to the same door staon are consistent.
Video Intercom D Series Door Staon User Manual
52