User's Manual

Note
•
The door
-unlocked duraon ranges from 1 s to 255 s.
•
If y
ou check Upload Alarm for Not-Closed Door, an alarm will be triggered
automacally if the door is not locked in the congured duraon.
•
Enabling Car
d Encrypt, the door staon can recognize the encrypted
informaon of the card when you swiping the card on the door staon.
3.
Se
t the Elevator Control parameters.
1) Select an elevator No., and select an elevator controller type for the elevator.
2) Set the
negave oor.
3) Select network interface as interface type. Enter the elevator controller's IP
address, port No., user name, and password.
4) Enable the elevator control.
Note
•
Up t
o 4 elevator controllers can be connected to one door staon.
•
Up t
o 10 negave
oors can be added.
•
Make sure the interface types of elevator controllers, which are connected
to the same door staon, are consistent.
I/O Input and Output
Steps
1.
Click I/O Input and Output t
o enter the I/O input and output sengs page.
Figure 6-11 I/O Input and Output
2.
Select I/O input No., input mode, output No., and output mode.
3.
Click Sa
ve to enable the sengs.
Video Intercom Face Recognion Door Staon with 4.3-inch Screen User Manual
26