User's Manual

Note
●
Up t
o 4 elevator controllers can be connected to one door staon.
●
Up to 10
negave oors can be added.
●
Make sure the interface types of elevator controllers, which are connected to
the same door staon are consistent.
RS-485 Sengs
Set the working mode to linked device.
St
eps
1. Click Access Control → RS-485 to enter the sengs page.
Figure 6-18 RS-485 Sengs
2. Select the No.
3. Select the w
orking mode.
4. Click Save to enable the sengs.
6.4.8 Smart Sengs
Biometrics Sengs
Adjust the face recognion parameters and ngerprint parameters according to your
needs.
Steps
1. Click Smart to enter the sengs page.
2. Enable f
ace an-spoong to edit face capture advanced parameters.
Video Intercom Face Recognion Door Staon User Manual
53