See Far,Go Further DS-3WF02C-5N/O Quick Start Guide
DS-3WF02C-5N/O Quick Start Guide Quick Start Guide COPYRIGHT ©2019 Hangzhou Hikvision Digital Technology Co., Ltd. ALL RIGHTS RESERVED. Any and all information, including, among others, wordings, pictures, graphs are the properties of Hangzhou Hikvision Digital Technology Co., Ltd. or its subsidiaries (hereinafter referred to be “Hikvision”).
DS-3WF02C-5N/O Quick Start Guide Catalog Applicable Models This manual is applicable to switches below: DS-3WF02C-5N/O (product series). Symbol Conventions The symbols that may be found in this document are defined as follows. Symbol DS-3WF02C-5N/O Quick Start Guide Description NOTE Provides additional information to emphasize or supplement important points of the main text.
DS-3WF02C-5N/O Quick Start Guide DS-3WF02C-5N/O Quick Start Guide Chapter 1 Introduction Indicator Indicators are used to monitor the status of the DS-3WF02C-5N/O. See the following table for 1.1 Overview DS-3WF02C-5N/O wireless bridge can be applied in industries, such as wireless video the description of the indicators.
DS-3WF02C-5N/O Quick Start Guide DS-3WF02C-5N/O Quick Start Guide Chapter 2 Installation Step 3 The schematic diagram of the installation of the device is as follows. Step 1 Select the unobstructed high point around the device to ensure that the devices are aligned and there is no obstruction in the middle. Fix the device as shown in the figure below.
DS-3WF02C-5N/O Quick Start Guide DS-3WF02C-5N/O Quick Start Guide Chapter 3 Prepare Ethernet 2 Properties Networking Sharing Step 1 Use a network cable to connect the computer to the LAN interface of the device or PoE Connect using: power supply to prepare the device. First, you need to configure the computer IP address and ASIX AX88179 USB 3.0 to Gigabit Ethernet Adapter the device's default IP address to be on the same network segment. Take the Windows 7 system Configure... as an example.
DS-3WF02C-5N/O Quick Start Guide DS-3WF02C-5N/O Quick Start Guide Chapter 4 Configuration After the preparation is completed, start the device configuration. Step 1 Make sure that the IP address of the computer is inconsistent with the default IP address of the device. On the same network segment, use a browser to log in to the device, open a browser, and enter the default IP address of the device in the address bar: 192.168.1.36.
DS-3WF02C-5N/O Quick Start Guide Wizard-Finish You have finished the wizard. please click ’Change’to save all your settings,and click’Apply’to reboot and make your settings work. Figure 4-4 Wizard – Finish Users can also click the “Wireless” bar at the top of the page to enter the “Wireless” page and modify the network name, frequency, key and other parameters.
