Quick Start Guide

DS-3WF02C-5N/O Quick Start Guide DS-3WF02C-5N/O Quick Start Guide

Step 3 The schematic diagram of the installation of the device is as follows.

Figure 2-3 Finish installation

Chapter 2 Installation

Step 1 Select the unobstructed high point around the device to ensure that the devices are

aligned and there is no obstruction in the middle. Fix the device as shown in the figure below.

Attach the back of the device to the pole, use the hoop to pass through the hoop hole on the

back of the device, tighten the hoop, and fix the device on the pole.

Figure 2-1 Install host

Figure 2-2 Power on the device

Step 2 Connect the PoE interface of the device to the PoE interface of the PoE power supply

through the network cable. The LAN interface of the device and the LAN interface of the PoE

power supply can be connected to the front-end network devices such as IPC through the

network cable, as shown in the following figure.

3 4

PoE Adapter

The PoE port of the device is connected to the PoE

port of the PoE adapter through a network cable.

Protective cover

LAN

POE

PoE Adapter

PoE

LAN

PoE