Quick Start Guide

DS-3WF02C-5N/O Quick Start Guide DS-3WF02C-5N/O Quick Start Guide
Figure 4-3 Wizard – Wireless
Figure 4-2 Wizard – Network
Step 3 Go to the “Wireless” page. The device can modify the wireless parameters such as
network name, frequency, and key through this page. The default wireless mode of the device is
the WDS Station. The default network name of the device is Wireless_R. When pairing with the
WDS Access Point device, please note that the key and the SSID on the WDS Station side must
be the same as the WDS Access Point. Other configurations are recommended to keep the
default values. Click "Next".
Step 4 Go to the Setup “Wizard – Finish” page and click “Change” to save the configuration.
Chapter 4 Configuration
After the preparation is completed, start the device configuration.
Step 1 Make sure that the IP address of the computer is inconsistent with the default IP address
of the device. On the same network segment, use a browser to log in to the device, open a
browser, and enter the default IP address of the device in the address bar: 192.168.1.36.
Figure 4-1 login
NOTE
When you log in to the device for the first time, click Enter, enter the device activate page.
The user name is admin, and the user password is set by the user. You also need to select your
password, country, language and time zone, as shown in Figure 4-1. Check "I agree to these
terms of use" and click "Activate”. Take the AP device as an example.
Step 2 Go to the device page and click the “Wizard” bar at the top of the page to enter the
“Network” page to set the IP address of the device. In the address field of the LAN IP, fill in
192.168.1.X, X is any integer from 2 to 253, and the address is not used. The subnet mask can be
used by default. Click “Next” when finished.
7 8
admin
Please set a password
Please confirm the password
Please select country code
Please select time zone
English
TERMS OF USE
Network
LAN IP:
LAN Netmask:
Gateway IP:
192.168.1.36
255.255.255.0
192.168.1.100
This wizard page is only used in bridge mode， helps to set the basic network parameters.
I agree to these terms of use
Installer must install this device professionally. It is the installer's responsibility to
follow local country regulations including operation within legal frequency
channels,output power requirements.
Username
New Password
Confirm Password
Country/Region
Time Zone
Language
Wireless Mode:
SSID:
Output Power:
IEEE802.11 Mode:
Channel Width:
Wireless Security[?]:
WPA2-PSK Key:
This wizard page helps to set the basic wireless and wireless security,Please click the top”Wireless”menu for
detail setting.
WDS Station
Wireless_R
A/N mixed
20 MHz
WPA
Allowing adjusting transmission power
Caution:It is installer`s responsibility to follow local regulations while
adjusting the transmission power
Wireless