User's Manual

Chapter 9 Network Conguraon
9.1 Set IP Address
IP address must be properly congured before you operate the device over network. IPv4 and IPv6
are both supported. Both versions can be congured simultaneously without conicng to each
other.
Go to Conguraon → Device Conguraon → System Conguraon → TCP/IP for parameter
sengs.
Figure 9-1 Set IP Address
NIC Type
Select a NIC (Ne
twork Interface Card) type according to your network condion.
IPv4
T
wo IPv4 modes are available.
Auto-Obtain
The device automacally gets the IPv4 parameters from the network if you check Aut
o-
Obtain. The device IP address is changed aer enabling the funcon. You can use SADP to get
the device IP address.
Note
The network that the device is connected to should support auto-obtain.
Manual
Parking Camera User Manual
29