User's Manual

Safety Instrucon
Laws and Regulaons
Use of the product must be in strict compliance with the local laws and regulaons. Please shut
down the device in prohibited area.
Power Supply
• Use of the product must be in strict compliance with the local electrical safety regulaons.
• Use the power adapter provided by qualied manufacturer. Refer to the product specicaon for
detailed power requirements.
• It is recommended to provide independent power adapter for each device as adapter overload
may cause over-heang or a re hazard.
• Make sure that the power has been disconnected before you wire or install the device.
• To avoid electric shock, DO NOT directly touch exposed contacts and components once the
device is powered up.
• DO NOT use damaged power supply devices (e.g., cable, power adapter, etc.) to avoid electric
shock, re hazard, and explosion.
• DO NOT directly cut the power supply to shut down the device. Please shut down the device
normally and then unplug the power cord to avoid data loss.
• DO NOT block the power supply equipment to plug and unplug conveniently.
• Make sure the power supply has been disconnected if the power adapter is idle.
• Make sure the device is connected to the ground rmly.
Transportaon, Use, and Storage
• To avoid heat accumulaon, good venlaon is required for a proper operang environment.
•
Store the device in dry, well-venlated, corrosive-gas-free, no direct sunlight, and no heang
source environment.
•
Avoid re, water, and explosive environment when using the device.
• Avoid lightning strike for device installaon. Install a lightning arrester if necessary.
• Keep the device away from magnec interference.
• Avoid device installaon on vibratory surfaces or places. Failure to comply with this may cause
de
vice damage.
• DO NOT touch the heat dissipaon component to avoid burns.
• DO NOT expose the device to extremely hot, cold, or humidity environments. For temperature
and humidity requirements, see device specicaon.
Parking Camera User Manual
vi