User's Manual

-
Click Add, and en
ter the SSID, working mode, and encrypon type. Click Connect. When the
Wi-Fi is c
onnected, click OK.
4.
Oponal: Set the WLAN parameters.
1) Click Network Sengs.
2)
Set the IP address, subnet mask, and default gateway. Or check Enable DHCP and the system
will allocate the IP address, subnet mask, and default gateway automacally.
5.
Click OK.
SIP Seng
Steps
1.
Click Ne
twork → Basic Sengs → SIP to enter the sengs page.
2.
Check Enable VOIP Gateway.
3.
Congure the SIP parameters.
4.
Click Save to enable the sengs.
Report Strategy Sengs
You can set the center group for uploading the log via the ISUP protocol.
Go to Conguraon → Ne
twork → Basic Sengs → Report Strategy .
You can set the center group and the system will transfer logs via ISUP protocol. Click Save to save
the sengs.
Center Group
Select a center group from the drop-down list.
Main Channel
The device will communicate with the center via the main channel.
Note
N1 refers to wired network.
Plaorm Access
Plaorm access provides you an opon to manage the devices via plaorm.
Steps
1.
Click Conguraon → Ne
twork → Advanced → Plaorm Access to enter the sengs page.
2.
Select the Plaorm Access Mode.
DS-K1T690 Series Face Recognion Terminal User Manual
90