User's Manual

RS-485 Address
Set the RS-485 Address according to your actual needs.
Note
If you select Access Con
troller: If connect the device to a terminal via the RS-485 interface, set
the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address
according to the door No.
Baud Rate
The baud r
ate when the devices are communicang via the RS-485 protocol.
Set Wiegand Parameters
You can set the Wiegand transmission direcon.
Steps
Note
Some device models do not support this funcon. Refer to the actual products when conguraon.
1.
Click Conguraon → Access Con
trol → Wiegand Sengs .
Figure 8-17 Wiegand Page
2.
Check Wieg
and to enable the Wiegand funcon.
3.
Se
t a transmission direcon.
DS-K1T690 Series Face Recognion Terminal User Manual
112