User's Manual

Figure 8-18 Access Control and Elevator Control
2.
Check Enable Elevator Control.
3.
Set the elevator parameters.
Elevator No.
Select an elevator No. for conguraon from the drop-down list.
Ele
vator Controller Type
Select an elevator controller from the drop-down list.
Interface Type
Select a communicaon type from the drop-down list for elevator communicaon.
If you select R
S-485, make sure you have connected the device to the elevator controller with
RS-485 wire.
If you select Network Interface, enter the elevator controller's IP address, port No., user
name, and password for communicaon.
Neg
ave Floor Capacity
Set the negave oor number.
DS-K1T690 Series Face Recognion Terminal User Manual
114