User's Manual

Note
●
Up t
o 4 elevator controllers can be connected to 1 device.
●
Up to 10 negave oors can be added.
●
Make sure the interface types of elevator controllers, which are connected to the same
device, are consistent.
8.6.24 Temperature Measurement Sengs
Temperature Measurement Sengs
You can set the temperature measurement parameters, including temperature measurement only,
t
emperature unit, over-temperature threshold, temperature compensaon, door not open when
temperature is abnormal, etc.
Steps
1.
Click Conguraon → Temperature → Temperature Sengs .
Figure 8-19 Temperature Measurement Sengs
2.
Enable T
emperature Measurement.
3.
Congure the temperature measurement parameters.
DS-K1T690 Series Face
Recognion Terminal User Manual
115