User's Manual

Note
●
Number
s, upper case leers, lower case leers, and special characters are allowed in the user
name.
●
Up to 32 characters are allowed in the user name.
5.
Oponal: Add a f
ace picture, ngerprints, cards, or Pin for the administrator.
Note
●
F
or details about adding a face picture, see
Add Face Picture .
●
Note
For details about adding a ngerprint, see Add Fingerprint .
●
F
or details about adding a card, see
Add Card .
●
F
or details about adding a password, see
View PIN code .
6.
Oponal: Se
t the administrator's authencaon type.
Note
For details about seng the
authencaon type, see
Set Authencaon Mode .
7.
Enable the Adminis
trator Permission funcon.
Enable Administrator Permission
The user is the administrator. Except for the normal aendance funcon, the user can also
enter the Home page to operate aer authencang the permission.
8.
Tap
to save the sengs.
7.3.2 Add Face Picture
Add user's face picture to the device. And the user can use the face picture to authencate.
Steps
Note
Up to 10,000 face pictures can be added.
1.
Long t
ap on the inial page for 3 s and slide to the le/right by following the gesture and log in
the backend.
2.
Tap User → + to enter the Add User page.
3.
Edit the employee ID.
Note
●
The emplo
yee ID should be less than 32 characters. And it can be a combinaon of lower
leers, upper leers, and numbers.
●
The employee ID should not be duplicated.
4.
T
ap the Name eld and input the user name on the so keyboard.
DS-K1T690 Series Face Recognion Terminal User Manual
55