User's Manual

Parameter Descripon
Note
●
Only the de
vice with the ngerprint module supports the
ngerprint related funcon.
●
Biometric recognion products are not 100% applicable to
an-spoong environments. If you require a higher security
level, use mulple authencaon modes.
●
If you adopt mulple authencaon modes, you should
authencate other methods before authencang face.
Reader Auth. Mode (Card
Reader Authencaon Mode)
Select the card reader's authencaon mode.
Enable NFC Card Enable the funcon and you can present the NFC card to
authencate.
Auth. via QR Code Aer enabling this funcon, you can put the QR code in front of
the device camera to authencate via QR code.
Door Contact You can select "Remain Open" or "Remain Closed" according to
your actual needs. By default, it is Remain Closed.
Open Duraon Set the door unlocking duraon. If the door is not opened for
the set me, the door will be locked. Available door locked me
range: 1 to 255s.
Authencaon Interval Set the device authencang interval. Available authencaon
interval range: 0 to 65535.
7.10 Preference Sengs
You can congure
preference sengs parameters.
Steps
1.
Tap Basic Sengs → Pr
eference Sengs to enter the preference sengs page.
DS-K1T690 Series Face Recognion Terminal User Manual
70