User's Manual

Note
The page may vary according to dierent device models. Refers to the actual page for details.
Capacity
Y
ou can view the number of administrator, user, face picture, card, and event.
Note
●
P
arts of the device models support displaying the ngerprint number. Refers to the actual
page for details.
●
The capacity varies according to the congured enrollment rules. For details about seng
enrollment rules, see .
Restore to Default
All par
ameters, except for the communicaon sengs, remotely imported user informaon, will
be restored to the default sengs. The system will reboot to take eect.
Restore to Factory
All parameters will be restored to the factory sengs. The system will reboot to take eect.
Upgrade
Plug the USB ash drive in the device USB interface. Tap Upgrade → OK , and the device will
read the digicap.dav le in the USB ash drive to start upgrading.
R
eboot
The device will reboot aer the conrmaon.
Exit
T
ap Exit to exit the applicaon.
Long tap , and en
ter admin password to view device version informaon.
7.12 Video Intercom
Aer adding the device to the client soware, you can call the device from the client soware, call
the main staon from the device, call the client soware from the device, call the indoor staon
from the device, or call the specic room from the device.
7.12.1 Call Client Soware from Device
Steps
1.
Ge
t the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2.
Run the client soware and the control panel of the soware pops up.
DS-K1T690 Series Face Recognion Terminal User Manual
73