User's Manual

7.12.3 Call Device from Client Soware
Steps
1.
Get the client soware
from the supplied disk or the ocial website, and install the soware
according to the prompts.
2.
Run the clien
t soware and the control panel of the soware pops up.
3.
Click Device Management to enter the Device Management page.
4.
Add the device to the client soware.
Note
For details about adding device, see Add De
vice.
5.
En
ter the Live View page and double-click the added device to start live view.
Note
For details about operaons in the Liv
e View page, see Live View in the user manual of the client
soware.
6.
Righ
t click the live view image to open the right-click menu.
7.
Click Start Two-Way Audio to start two-way audio between the device and the client soware.
7.12.4 Call Room from Device
Steps
1.
Get the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2.
Run the clien
t soware and the control panel of the soware pops up.
3.
Click Device Management to enter the Device Management interface.
4.
Add the indoor staon and the device to the client soware.
Note
For details about adding device, see Add De
vice.
5.
Link a user t
o an indoor staon and set a room No. for the indoor staon.
6.
Call the r
oom.
-
If you have congured a specied room No. in the
Basic Sengs , you can tap to call the
r
oom.
-
If you have not congured a specied room No. in the
Basic Sengs , you should tap on
the
authencaon page of the device. Enter the room No. on the dial page and tap
to call
the r
oom.
7.
Aer the indoor staon answers the call, you can start two-way audio with the indoor staon.
DS-K1T690 Series Face
Recognion Terminal User Manual
75