User's Manual

All registered pictures in the device will be deleted.
Clear Captured Pictures
All captured pictures in the device will be deleted.
Set Face
Recognion Parameters
You can set face recognion parameters for accessing.
Click Conguraon → Access Con
trol → Face Recognion Parameters .
You can set Working Mode as Access Control Mode. The access control mode is the device normal
mode. You should authencate your credenal for accessing.
Enable Blocklist Authencaon.
Click Save to save the sengs aer the conguraon.
Set Card Security
Click Conguraon → General → Card Security to enter the sengs page.
Set the parameters and click Save.
Enable NFC Card
In order to prevent the mobile phone from geng the data of the access control, you can
enable NF
C card to increase the security level of the data.
Enable M1 Card
Enable M1 card and authencateing by presenng M1 card is available.
M1 Car
d Encrypon
Sector
M1 card
encrypon can improve the security level of authencaon.
Enable the funcon and set the encrypon sector. By default, Sector 13 is encrypted. It is
recommended to encrypt sector 13.
Enable EM Card
Enable EM card and authencang by presenng EM card is available.
Note
If the peripheral card reader supports presenng EM card, the funcon is also supported to
enable/disable the EM c
ard funcon.
Enable DESFire Card
The de
vice can read the data from DESFire card when enabling the DESFire card funcon.
DESFire Card Read Content
DS-K1T981 Series Access Control Terminal User Manual
96