User's Manual

-
If disable DHCP
, you should enter the IP address, the subnet mask, and the gateway manually.
6. Tap OK to save the sengs and go back to the Wi-Fi tab.
7. T
ap to save the network parameters.
7.2.3 Set RS-485 Parameters
The face recognion terminal can connect external access controller, secure door control unit or
card reader via the RS-485 terminal.
Steps
1. Tap Comm. (Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2. On the Communicaon Sengs page, tap RS-485 to enter the RS-485 tab.
Figure 7-6 Set RS-485 Parameters
3. Select an peripher
al type according to your actual needs.
DS-K1T981 Series Access Control Terminal User Manual
42