User's Manual

2. On the Home page, tap Data → Export Data .
3. Tap Face Data, Event Data, User Data, Access Control Parameters or Iris Data.
Note
The exported access control parameters are conguraon
les of the device.
4. Oponal: Cr
eate a password for exporng. When you import those data to another device, you
should enter the password.
Note
●
The support
ed USB ash drive format is DB.
●
The system supports the USB ash drive with the storage of 1G to 32G. Make sure the free
space of the USB ash drive is more than 512M.
●
The exported user data is a DB le, which cannot be edited.
●
Do not remove USB ash drive when exporng data.
7.5 Identy
Authencaon
Aer network conguraon, system parameters conguraon and user conguraon, you can go
back to the inial page for identy authencaon. The system will authencate person according
to the congured authencaon mode.
7.5.1 Authencate via Single Credenal
Set the user authencaon type before authencaon. For details, see
Set Authencaon Mode .
Authencate
face, ngerprint, card or QR code.
Face
Face forward at the camera and start authencaon via face.
Iris
Look a
t the camera and make your eyes in frame and start authencaon via iris.
Fingerprint
Place the enrolled
ngerprint on the ngerprint module and start authencaon via ngerprint.
Card
Present the card on the card presenng area and start authencaon via card.
Note
The card can be normal IC card, or encrypted card.
QR Code
Put the QR c
ode in front of the device camera to authencate via QR code.
DS-K1T981 Series Access Control Terminal User Manual
56