User's Manual

Note
Authencaon via QR code should be supported by the device.
Password
En
ter the password to authencate via password.
If authencaon completed, a prompt "Authencated" will pop up.
7.5.2 Authencate via Mulple Credenal
Before You Start
Set the user authencaon type before authencaon. For details, see
Set Authencaon Mode .
St
eps
1. If the authencaon mode is mulple, authencate any credenal according to the instrucons
on the live view page.
Note
●
The c
ard can be normal IC card, or encrypted card.
●
If the QR Code Scanning funcon is enabled, you can put the QR code in front of the device
camera to authencate via QR code.
●
If the authencaon mode is mulple, iris authencaon mode precedes other
authencaon modes.
2. Aer the previous credenal is authencated,
connue authencate other credenals.
Note
●
F
or detailed informaon about scanning ngerprint, see Tips for Scanning Fingerprint.
●
For detailed informaon about authencang face, see Tips When Collecng/Comparing Face
Picture.
If
authencaon succeeded, the prompt "Authencated" will pop up.
7.6 Basic Sengs
You can set the shortcut key, voice sengs, me sengs, sleeping (s), community No., building
No., Unit No.
Long tap on the inial page for 3 s and slide to the le/right by following the gesture and login the
de
vice home page. Tap Basic.
DS-K1T981 Series Access Control Terminal User Manual
57