User's Manual
Table Of Contents
- Legal Information
- Symbol Conventions
- Regulatory Information
- 1 Appearance
- 2 Terminal and Wiring
- 3 Installation
- 4 Activation
- 5 Configuration via Client Software
- 5.1 Device Management
- 5.2 Live View via Door Station
- 5.3 Remote Configuration
- 5.4 Organization Management
- 5.5 Person Management
- 6 Video Intercom Operation
- A. Communication Matrix and Device Command
Note
•
Bit 1, 2, 3, 4 are used to coding the sub module address. Bit 5, 6, 7 are
reserved. Set Bit 8 as on to enable a resistance (120Ω).
•
Valid sub module address is from 1 to 8. The address should be unique for
connecng to the main unit.
The sub module address and its corresponding switch status are displayed as
below.
Table 3-1 Descripon
Sub
Module
Address
1 2 3 4 5 6 7 8
Bit 1 ON OFF ON OFF ON OFF ON OFF
Bit 2 OFF ON ON OFF OFF ON ON OFF
Bit 3 OFF OFF OFF ON ON ON ON OFF
Bit 4 OFF OFF OFF OFF OFF OFF OFF ON
3.2 One-Module Installaon
3.2.1 One-Module Surface Mounng
Video Intercom Module Door Staon User Manual
16