User's Manual
Table Of Contents
- Legal Information
- Symbol Conventions
- Regulatory Information
- 1 Appearance
- 2 Terminal and Wiring
- 3 Installation
- 4 Activation
- 5 Configuration via Client Software
- 5.1 Device Management
- 5.2 Live View via Door Station
- 5.3 Remote Configuration
- 5.4 Organization Management
- 5.5 Person Management
- 6 Video Intercom Operation
- A. Communication Matrix and Device Command
Steps
1.
Drill an installaon hole, and pull the cables out.
Note
•
The suggested dimension of installaon hole is 118 (W) × 108 (H) × 45.5 (D)
mm.
•
The suggested length of cables le outside is 100 mm.
Figure 3-9 Drill Installaon Hole
2.
Remove the plasc sheet of the cable entry.
3.
Mark the gang box screw holes on the wall.
1) Route the cables through the gang box hole.
2) Insert the gang box into the
installaon hole.
3) Mark the gang box screw holes' posion with a marker, and take out the
gang box.
Figure 3-10 Mark the Screw Holes
Video Intercom Module Door Staon User Manual
21