User's Manual

Figure 5-22 Elevator Control
2.
Check to enable elevator control funcon.
3.
Select an Elevator No., and select an elevator controller type for the elevator.
4.
Select Interface Type.
5.
Enter Negave Floor Capacity, and select Alarm Receiver Type.
6.
Enter the elevator controller's Server IP Address, Port No., User Name, and
Password.
7.
Click Save to enable the sengs.
Note
•
Up to 4 elevator controllers can be connected to one door staon.
•
Up to 10 negave oors can be added.
•
Make sure the interface types of elevator controllers, which are connected
to the same door staon are consistent.
Video Intercom Module Door Staon User Manual
83