Service Manual
Table Of Contents
- Table of Contents
- Intended Use
- Introduction
- Symbols
- Safety Instructions
- Quick View™ List of Features
- Prepare the System for Use
- Transport The Bed
- Cleaning and Disinfecting
- Preventive Maintenance
- Storage and Handling
- Expected Life
- Troubleshooting
- Replacement Parts
- Service Part Replacement Procedures
- Setup
- 1.1 Reader Replacement
- 1.2 Power Cable Replacement
- 1.3 Indicator Light Assembly Replacement
- 1.4 Antenna Assembly Replacement
- 1.5 Graphic Replacement for the Head, Seat, and Thigh Sections, and Deck Filler—Progressa® Bed
- 1.6 Equipment Call Cable Replacement
- 1.7 Label Replacement
- 1.8 WatchCare™ System Function Check
- Specifications
- Limited Warranty
WatchCare™ Incontinence Management System User and Service Manual (196414 REV 2)
17
Preventive Maintenance
STEP 2: Disinfection
a. With a new or clean wiping cloth soaked in an approved
cleaner/disinfectant, use light pressure to wipe all exterior
surfaces of the reader, indicator light, and antennas.
b. Make sure all surfaces remain wet with the
cleaner/disinfectant for the specified contact time. Re-wet
surfaces with a new wiping cloth as necessary. See “Table 1:
Approved Cleaners/Disinfectants” on page 15 for the contact
time.
NOTE:
If bleach is used with another cleaner/disinfectant, use a new or clean
cloth/wipe soaked in tap water to remove any disinfectant residue
prior to and after the bleach application.
Prepare for Use
a. Make sure the mattress is in position for use and is connected
to the bed. Refer to the bed’s service manual.
b. Plug the bed into an applicable power outlet.
PREVENTIVE MAINTENANCE
The WatchCare™ System does not require preventive maintenance.
STORAGE AND HANDLING
Store the WatchCare™ smart pads in a dry location that is at least 2 feet (61
cm) from a bed with the WatchCare™ System.
EXPECTED LIFE
The expected life of the WatchCare™ System hardware is 10 years. The
smart pads are intended for single use only.
DRAFT 26-FEB-2019