Service Manual
Table Of Contents
- Table of Contents
- Intended Use
- Introduction
- Symbols
- Safety Instructions
- Quick View™ List of Features
- Prepare the System for Use
- Transport The Bed
- Cleaning and Disinfecting
- Preventive Maintenance
- Storage and Handling
- Expected Life
- Troubleshooting
- Replacement Parts
- Service Part Replacement Procedures
- Setup
- 1.1 Reader Replacement
- 1.2 Power Cable Replacement
- 1.3 Indicator Light Assembly Replacement
- 1.4 Antenna Assembly Replacement
- 1.5 Graphic Replacement for the Head, Seat, and Thigh Sections, and Deck Filler—Progressa® Bed
- 1.6 Equipment Call Cable Replacement
- 1.7 Label Replacement
- 1.8 WatchCare™ System Function Check
- Specifications
- Limited Warranty
WatchCare™ Incontinence Management System User and Service Manual (196414 REV 2)
47
1.5 Graphic Replacement for the Head, Seat, and Thigh Sections, and Deck Filler—
e. Remove the other adhesive
covering from the new
antenna gasket. Make sure
the antenna is in the correct
orientation and location on
the graphic. Then, firmly
press the antenna into
position for 10 seconds with
approximately 75 lb (34 kg)
of force.
7. The replacement is complete. Do the function checks on page 53 and
in the bed’s service manual. As you operate the bed’s articulation
functions, make sure the cables are not in a location where they
could get damaged or pinched.
DRAFT 26-FEB-2019