Product Manual A

The Hilliard Corporation

100 West Fourth Street

Elmira, New York 14902-1504

8444-7F-010

Released (04/21/09)

Rev. A 3/19/10

THESE INSTALLATION INSTRUCTIONS MUST BE FOLLOWED FOR PROPER OPERATION. FAILURE TO DO SO

CAN RESULT IN SEVERE INJURY OR DEATH. FOR QUESTIONS REGARDING INSTALLATION CONTACT

EXTREMEDUTY@HILLIARDCORP.COM, OR VISIT US AT WWW.HILLIARDEXTREMEDUTY.COM

PAGE 1
The Hilliard Corporation 100 West Fourth Street Elmira, New York 14902-1504 THESE INSTALLATION INSTRUCTIONS MUST BE FOLLOWED FOR PROPER OPERATION. FAILURE TO DO SO CAN RESULT IN SEVERE INJURY OR DEATH. FOR QUESTIONS REGARDING INSTALLATION CONTACT EXTREMEDUTY@HILLIARDCORP.COM, OR VISIT US AT WWW.HILLIARDEXTREMEDUTY.COM 8444-7F-010 Released (04/21/09) Rev.
PAGE 2
Installation: All LD4S series clutches are loose assemblies and need to be assembled properly to allow the clutch to operate safely. These steps must be followed to ensure proper installation. 1. Verify the size of the engine crankshaft matches the bore size purchased. Typically 3/4 or 5/8 of an inch. 2. Oil the clutch bushing using several drops of lightweight oil. Make sure the clutch is less than 120 degrees Fahrenheit prior to applying oil. (Any non synthetic oil is acceptable. DO NOT GREASE) 3.