Instructions

Network Bullet Camera·Quick Start Guide

Figure 2-2 Fix the Camera on the Ceiling/Wall

Note:

 In the supplied screw package, both self-tapping screws, and

expansion bolts are contained.

 If the ceiling is cement, expansion bolts are required to fix the

camera. If the ceiling is wooden, self-tapping screws are required.

5. Connect the corresponding power cord, and network cable.

6. Power on the camera, and set the network configuration (for

details, refer to 3 Set the Network Camera over the LAN and 4

Access via Web Browser) to check whether the image is gotten

from the optimum angle. If not, adjust the surveillance angle.

1) Loosen the No.1 adjusting screw to adjust the rotation

position [0° to 360°].

2) Tighten the No.1 adjusting screw.

3) Loosen the No.2 adjusting screw to adjust the tilting position

[-90° to 90°].

4) Tighten the No. 2 adjusting screw.