Instructions

Network Speed Dome·Quick Start Guide
5
Steps:
1. Disassemble the speed dome.
1) Loosen three screws and remove the bubble.
2) Remove the protective lens cover, foam, and sticker.
Protective Foam
Protective Sticker
Bubble
Figure 2-2 Disassemble the Speed Dome
2. Install the memory card.
Memory Card Slot
Figure 2-3 Memory Card Slot
3. Drill screw holes in the ceiling.
1) Attach the drill template to the ceiling where you want to install the speed
dome.
2) Cut a hole and drill screw holes according to the drill template.
Note:
±2 mm of the circle diameter is tolerable.
4. Install the toggle bolts.
1) Remove the toggle from the toggle bolt.
2) Insert the bolts into the screw holes on the speed dome as shown in Figure 2-4.