Use and Care Manual

620-690nm/0.95mW max.
CLASS II LASER PRODUCT
LASER RADIATION - DO NOT
STARE INTO BEAM
CAUTION
>1/4s
Symbols
Read the
operating
instructions
before use.
Disposal of
power tools or
appliances and
batteries
together with
household
waste is not
permissible.
On the tool
Do not stare into the beam.
Laser warning plates for the USA in accordance with
CFR 21 § 1040 (FDA).
On the tool
Laser radiation. Do not look into the beam. Laser
class 2.
Laser warningplateaccordingto IEC60825/EN60825-
1:2007
Location of identification data on the tool
The type designation and serial number can be found
on the type identification plate on the tool. Make a
note of this data in your operating instructions and
always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Generation: 01
Serial no.:
2. Description
2.1 Use of the product as directed
The PM 2-P is a self-leveling point laser which allows a single person to carry out vertical alignment work
quickly and accurately. The tool features two coincident laser beams (beams that originate from the same
point). All beams have the same range of 30 m (range depends on the brightness of ambient light).
The tool is designed to be used to mark plumb points, mainly in interiors.
When used for outdoor applications, care must be taken to ensure that the general conditions are similar to
those encountered indoors. Possible applications are:
Transferring measuring marks from the floor to the ceiling.
Modification of the tool is not permissible.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
2.2 Features
The PM 2-P levels itself automatically within a range of approx. 4°.
Self-leveling takes only approx. 3 seconds.
When the self-leveling range is exceeded, the laser beam blinks to warn the user.
The PM 2-P is characterized by its ease of operation and use, its rugged plastic casing and ease of transport
due to its compact dimensions and light weight.
When in normal operating mode, the tool switches itself off after 15 minutes. Sustained operating mode is
possible by switching on, switching off and switching on again within 3 seconds.
en
12